All tools
viewhub.stream - Engineering Tools

Speaker Cable Size Calculator

Estimate a suitable copper conductor size for speaker circuits, constant-voltage (100V / 70V) or low-impedance (2Ω / 4Ω / 8Ω / 16Ω), based on wattage per run and one-way cable distance. Calculate up to 8 speaker runs at once.

Power-loss method Up to 8 runs Guidance only - verify on site
⚙️
Line settings

System parameters

Power loss is the proportion of a speaker run's rated wattage dissipated as heat in the cable rather than delivered to the speakers. Lower percentages need thicker cable but preserve level and damping factor over distance.

🔊
Speaker runs

Enter up to 8 runs

Run label Total tapped wattage (W) One-way cable run (m)

"Total tapped wattage" is the sum of all speaker tap settings on that one cable run, not the individual speaker rating. "Cable run" is the one-way distance from amplifier/line output to the far end of that run.

📋
Quick reference

Typical cable size vs. distance (100V constant-voltage line, 5% max loss)

Reference only, and specific to 100V constant-voltage lines. Use the calculator above for 70V or low-impedance runs, or for your actual wattages. Sizes shown are the smallest standard copper CSA keeping power loss at or below 5% at 100V.

One-way distance 50W run 100W run 200W run 300W run 500W run

Disclaimer: This calculator provides estimates only, based on the power-loss method, and is offered for general guidance. viewhub.stream accepts no responsibility or liability for any loss, damage, injury or cost arising from the use of, or reliance on, these results. Always verify cable selection against the manufacturer's data and applicable regulations, and consult a qualified installer.