Before you start
Choosing the right type of loudspeaker matters more than choosing the best brand. A beautiful column speaker in a nightclub, or a powerful line array in a small meeting room, will sound worse than a modest speaker of the right type. Each type exists because it solves a particular problem: covering a wide area evenly, throwing sound a long way, controlling reflections in a reverberant room, disappearing into the décor, or surviving outdoors. This guide explains the main types, how their coverage works, what each is good at and where you would use it.
For the electrical side (100 V line and low impedance), see 100 V Line Speaker Systems. For subwoofers, see Subwoofers: Sizing, Placement and Arrays.
Understanding coverage
Every loudspeaker sends sound out in a pattern. Data sheets describe it with a few key figures:
- Coverage angle (dispersion): the angle within which the level stays within 6 dB of the level straight in front, quoted horizontally and vertically, for example 90° × 60°. Outside that angle the level drops quickly.
- Directivity: how strongly a speaker focuses its sound forwards. A narrow pattern puts more sound where you want it and less on walls and ceilings, which matters in reverberant rooms.
- Pattern control at low frequencies: coverage angles are usually measured in the upper mid frequencies. At low frequencies, most speakers spread sound in all directions, including behind them. Only large speakers, arrays or special designs control the pattern in the bass.
- Sensitivity and maximum SPL: how loud the speaker is for a given power, and how loud it can go. See Audio Basics.
- How level falls with distance: a single speaker loses about 6 dB each time the distance doubles. Tall line sources lose only about 3 dB per doubling over part of their range, which is why they can cover long rooms more evenly.
The Speaker Coverage & SPL Calculator shows the area a speaker covers and the level across it.
The types at a glance
| Type | Typical coverage | Strengths | Typical uses |
|---|---|---|---|
| Ceiling | 90° to 180° conical | Even, unobtrusive coverage from many speakers | Shops, offices, restaurants, hotels, paging |
| Surface (wall-mount) two-way | 90° × 60° to 110° × 90° | Easy to fit, fuller sound than ceiling speakers | Bars, gyms, meeting rooms, small venues |
| Pendant | 120° to 360° | Brings sound down from high or open ceilings | Warehouses, atriums, open-ceiling retail |
| Point source PA | 90° × 40° to 60° × 40°, often rotatable | Loud, clear, good pattern control in the mids and highs | Events, halls, theatres, clubs, worship |
| Column (line source) | 120° to 150° horizontal, narrow vertical | Controls reflections, throws further, slim and discreet | Churches, reverberant halls, lecture rooms, stations |
| Steerable column | Wide horizontal, electronically aimed vertical beams | Places sound precisely in difficult acoustics | Cathedrals, transport hubs, large reverberant spaces |
| Line array | 90° to 120° horizontal, vertical set by the angles between boxes | Long throw, even level front to back, high output | Large venues, festivals, arenas, large auditoriums |
| Flat panel (distributed mode) | Very wide, up to about 180° | Diffuse sound, can be almost invisible or paintable | Museums, galleries, boardrooms, heritage buildings, homes |
| Horn (re-entrant) | Around 60° to 110° | Very efficient, weatherproof, cuts through noise | Paging in factories, car parks, outdoor areas, sports grounds |
| Outdoor and landscape | Varies | Weatherproof, disguised as rocks or bollards | Gardens, terraces, theme parks, pools |
| Soundbar | Wide horizontal | Compact, often built into video bars | Huddle rooms, displays, small meeting rooms |
| Stage monitor | Around 40° to 90° | Angled at performers, compact | Stages, worship, rehearsal |
Ceiling speakers
Ceiling speakers fit into suspended or plasterboard ceilings and fire downwards, each covering a circle of floor beneath it. Many speakers spaced on a grid give even, low-level sound everywhere, with nothing visible but a grille.
- Coverage: typically 90° to 120° for standard models, and up to about 180° for wide-dispersion designs that suit low ceilings. The area covered depends on the height above the listeners' ears.
- Good for: background music, paging, speech reinforcement in offices and corridors, voice alarm (with EN 54-24 approved models).
- Limits: modest maximum level and bass, and many speakers are needed in low ceilings. Not suitable above about 5 to 6 m.
- Choose: back boxes for better bass and to stop sound leaking into the ceiling void, coaxial two-way models for clarity, larger drivers for higher ceilings, fire-rated or fire-domed models where needed.
See How to Set Up Background Music for spacing, and the Ceiling Speaker Layout Planner.
Surface and wall-mount speakers
Compact two-way cabinets on brackets, mounted on walls, beams or ceilings and aimed at the listening area.
- Coverage: commonly 90° × 60° to 110° × 90°. Wider models suit close listeners; narrower ones throw further.
- Good for: bars, restaurants, gyms, meeting rooms, small venues and anywhere there is no suitable ceiling. More level and bass than ceiling speakers.
- Limits: visible, and harder to make even in large rooms because listeners near a speaker hear much more than those further away.
- Placement: about 2.2 to 3 m high, tilted down so the axis points at the far side of the area covered, and staggered on opposite walls in long rooms.
Pendant speakers
Pendants hang on a cable from a high or open ceiling, bringing the speaker down closer to the listeners.
- Coverage: very wide, often 180° downwards and some up to 360°, so they can be spaced further apart than ceiling speakers.
- Good for: open soffits, warehouses, industrial-style restaurants, atriums and retail with exposed services, where ceiling speakers are impossible and surface speakers would be too far away.
- Limits: visible, and need secure suspension with secondary safety wires.
Point source PA speakers
The familiar trapezoidal or rectangular PA cabinet, with a woofer and a high-frequency compression driver on a horn. The horn controls the coverage pattern in the mid and high frequencies.
- Coverage: typically 90° × 40°, 60° × 40° or 90° × 60°. Many horns can be rotated for use on their side, and some are asymmetric to cover near and far seats evenly.
- Good for: events, halls, theatres, clubs, houses of worship and small to medium venues. Available passive or powered, from small speech boxes to large high-output cabinets.
- Limits: level falls quickly with distance, so very long rooms need delay speakers or a line array. Pattern control is lost at low frequencies.
- Placement: high enough to clear the audience, aimed at the back third of the audience, with the horn's coverage matched to the room. Use the narrow vertical pattern to keep sound off the ceiling and stage.
Column speakers
A column is a tall, slim speaker with many small drivers stacked vertically. Stacking the drivers narrows the vertical coverage, so sound goes towards the listeners rather than onto the floor and ceiling.
- Coverage: wide horizontally (typically 120° to 150°) and narrow vertically, with the vertical pattern depending on the column's length and the frequency.
- Good for: reverberant rooms, where keeping sound off hard surfaces improves speech clarity: churches, sports halls, lecture theatres, transport hubs. Their slim shape also suits architecturally sensitive spaces.
- Throw: because sound spreads less vertically, columns lose less level with distance than point sources, so a pair at the front can often cover a longer room.
- Portable columns with a separate subwoofer are popular for small events, DJs and solo performers: easy to carry, set up quickly and give wide horizontal coverage.
- Placement: mount with the bottom of the column around head height or just above, tilted slightly down if needed, so the narrow beam lies over the audience.
Steerable columns
Steerable (digitally controlled) columns have a separate amplifier and processing for each driver. Software shapes and aims the vertical beam, or several beams, electronically, so the column can hang flat on a wall yet aim its sound down at the audience and keep it off the floor, balcony fronts and ceiling. They are the standard choice for very reverberant spaces such as cathedrals and stations, where conventional speakers make speech unintelligible.
Line arrays
A line array is a vertical column of identical boxes, hung (flown) or stacked, with small angles between them. The boxes work together as one long source.
- Coverage: the horizontal coverage is set by each box (commonly 90°, 100° or 120°). The vertical coverage is set by the number of boxes and the angles between them (splay): smaller angles at the top for the back of the room, larger angles at the bottom for the front.
- Throw: the long source loses less level with distance over much of its range, so level stays more even from front to back than with point sources.
- Good for: large venues, festivals, arenas, theatres and large auditoriums, and increasingly mid-sized rooms with compact arrays.
- Limits: need rigging points, prediction software to design the angles and a processor or manufacturer's presets. A short array of two or three boxes does not behave as a line array at low and mid frequencies: it acts more like a point source.
- Design: use the manufacturer's prediction software to choose the number of boxes, trim height, angles and processing, then rig to the design using approved flying hardware and rated points.
Flying speakers is a specialist job. Only trained, competent riggers should fly speakers, using the manufacturer's approved hardware, from points rated for the load, with secondary safety. Follow LOLER and the venue's rigging rules.
Flat panel speakers
Flat panel (distributed mode) speakers use an exciter to vibrate a flat panel across its whole surface, instead of moving a cone back and forth. They can be very thin, mounted flush, printed with artwork, or plastered and painted over so they become invisible.
- Coverage: very wide, up to about 180°, and diffuse: the level changes little as you move around, and the sound does not seem to come from one point.
- Good for: museums, galleries, heritage buildings, boardrooms, hotels, luxury homes and anywhere the speaker must disappear. Their diffuse sound suits background music and speech at moderate levels, and their wide coverage reduces hot spots in small rooms.
- Limits: limited bass and maximum level, so they often need a subwoofer, and they are not a choice for loud music or large spaces. Invisible versions must be installed carefully by experienced plasterers following the manufacturer's method.
Horn and outdoor speakers
Re-entrant horns
- Folded horns that are very efficient and weatherproof, producing high levels from small amounts of power, usually on 100 V line.
- Coverage: typically 60° to 110°. Sound is focused on speech frequencies, cutting through noise, but with little bass, so they are not suitable for good-quality music.
- Good for: paging and alarms in factories, warehouses, car parks, railway platforms and sports grounds.
Outdoor speakers
- Weatherproof surface speakers (IP rated) for terraces, pools and outdoor bars, ideally under cover to extend their life.
- Landscape speakers disguised as rocks, planters or bollards, and in-ground subwoofers, for gardens and parks.
- Outdoors there are no walls to reflect sound, so more speakers at lower level, aimed into the site and away from neighbours, give better results than a few loud ones.
Other types
- In-wall speakers: like ceiling speakers but mounted in walls, often in home cinemas, boardrooms and hotel rooms.
- Soundbars and video bars: a wide, slim speaker under a display, often with microphones and a camera for video calls. Fine for small rooms.
- Stage monitors (wedges): angled cabinets on the stage floor aimed at performers, with a pattern that helps keep sound away from microphones.
- Coaxial speakers: the tweeter sits in the centre of the woofer, so both radiate from the same point. Even, symmetrical coverage, useful for close listening, monitors and ceilings.
- Powered speakers: with amplifiers and processing built in, needing only mains power and a line-level signal. Most portable PA is now powered.
Choosing the right type
| Situation | Usually best | Why |
|---|---|---|
| Office, shop or restaurant with a normal ceiling | Ceiling speakers | Even coverage at low level, invisible |
| Bar, gym or room with no usable ceiling | Surface speakers, plus a subwoofer | Easy to fit, more level and bass |
| High or open ceiling | Pendants | Bring the sound down to the listeners |
| Reverberant church, hall or station | Columns, or steerable columns in very difficult spaces | Keep sound off hard surfaces for clear speech |
| Event or medium venue | Point source PA with subwoofers | Loud, clear and flexible |
| Large venue, long throw | Line array with subwoofers | Even level front to back at high output |
| Heritage or design-led interior | Flat panel or slim columns | Discreet or invisible |
| Noisy industrial or outdoor paging | Horn speakers | Efficient and cut through noise |
| Small meeting room | Video bar or soundbar, or ceiling speakers | Simple and close to the display |
Questions to ask
- What is the main purpose: speech, background music, live music or alarms?
- How big is the area, how high is the ceiling, and how far is the furthest listener?
- How reverberant is the space?
- What level is needed, and how much bass?
- Can the speakers be seen, and where can they be mounted or rigged?
- Indoors or outdoors, and is it a fire-rated or voice alarm system?
- 100 V line or low impedance, powered or passive?